Engineering in PAA
14.9 Hardware engineering with the configuration tool
5. Click on the "Create" button.
Note
If the "Create" button is pressed a second time a new station is created.
6. Subsequently you find the HW under the location structure in the selected target node.
7. In addition the corresponding MLFB is generated and entered as the "MLFB" line under the
"Description".
The MLFB is then also available at the "Object > "Attributes" tab > > "Order data" tab >
Article number".
Result
The hardware including the required components is created in the Navigator under the location
defined as target object.
During the creation of the hardware, rules that are compatible with PCS 7 HW Config are
applied.
14.9.3
Configuring ET 200 stations using HW configuration tool
Requirement
The required PCS 7 version is selected using the "Select version" in the "Customer settings"
categories of the properties windows of the project .
Note
Only the modules of the selected PCS 7 version will be available.
124
Plant Automation Accelerator 3.0
Operating Manual, 04/2019, A5E46351208-AA