Analog Output Step Test - Teledyne T360 Operation Manual

Operating Instructions

4.13.3. Analog Output Step Test

SAMPLE RANGE = 500.000 PPM
< TST TST > CAL
SETUP X.X PRIMARY SETUP MENU
CFG DAS RNGE PASS CLK
SETUP X.X SECONDARY SETUP MENU
COMM VARS DIAG ALRM
SETUP X.X ENTER DIAG PASS: 818
8 1 8
134
This test can be used to check the accuracy and proper operation of the analog
outputs. The test forces all four analog output channels to produce signals
ranging from 0% to 100% of the full scale range in 20% increments. This test is
useful to verify the operation of the data logging/recording devices attached to the
analyzer.
To begin the Analog Output Step Test press:
CO2 =X.XXX
SETUP
MORE EXIT
EXIT
ENTR EXIT
Teledyne API Model T360/T360M Operation Manual
DIAG SIGNAL I / O
NEXT
DIAG ANALOG OUTPUT
PREV NEXT
DIAG AOUT ANALOG OUTPUT
0%
DIAG AOUT ANALOG OUTPUT
[0%]
Pressing the "0%" button while performing the test will
pause the test at that level. Brackets will appear around
the value: example: [20%] Pressing the same button again
will resume the test.
ENTR EXIT
ENTR EXIT
Performs
analog output
step test.
0% - 100%
EXIT
Exit-Exit
returns to the
DIAG menu
EXIT
07272B DCN6552