Teledyne T360 Operation Manual page 161

Teledyne API Model T360/T360M Operation Manual
SAMPLE*
< TST TST > CAL
SETUP X.X
CFG DAS RNGE PASS CLK
EXIT returns to
the previous
SETUP X.X
menu
COMM
SETUP X.X
ID INET
4.15.2.7. COM PORT PASSWORD SECURITY
07272B DCN6552
To initialize the modem press:
RANGE = 500.000 PPM
PRIMARY SETUP MENU
MORE
SECONDARY SETUP MENU
VARS DIAG ALRM
COMMUNICATIONS MENU
COM1 COM2
EXIT returns to the
Communications Menu.
In order to provide security for remote access of the T360, a LOGON feature can
be enabled to require a password before the instrument will accept commands.
This is done by turning on the SECURITY MODE (Mode 4, Section 4.11.5).
Once the SECURITY MODE is enabled, the following items apply.

A password is required before the port will respond or pass on commands.

If the port is inactive for one hour, it will automatically logoff, which can also
be achieved with the LOGOFF command.

Three unsuccessful attempts to log on with an incorrect password will cause
subsequent logins to be disabled for 1 hour, even if the correct password is
used.

If not logged on, the only active command is the '?' request for the help
screen.

The following messages will be returned at logon:

LOGON SUCCESSFUL - Correct password given

LOGON FAILED - Password not given or incorrect

LOGOFF SUCCESSFUL - Connection terminated successfully
To log on to the Model T360 analyzer with SECURITY MODE feature enabled,
type:
LOGON 940331
CO2 =X.XXX
SETUP
SETUP X.X
SET>
EXIT
SETUP X.X
<SET SET>
EXIT
SETUP X.X
<SET SET>
EXIT
SETUP X.X
<SET SET> INIT
SETUP X.X
<SET SET> INIT
Operating Instructions
COM1 MODE:0
EDIT
COM1 BAUD RATE:19200
EDIT
COM1 MODEM INIT:AT Y &D &H
EDIT
COM1 INITIALIZE MODEM
EXIT
INITIALIZING MODEM
EXIT
EXIT
EXIT
EXIT
159