Table 4-11: Lan/Internet Configuration Properties - Teledyne T360 Operation Manual

Teledyne API Model T360/T360M Operation Manual

Table 4-11: LAN/Internet Configuration Properties

PROPERTY DEFAULT STATE
DHCP
INSTRUMENT
IP ADDRESS
GATEWAY IP
ADDRESS
SUBNET MASK
1
TCP PORT
HOST NAME
1
Do not change the setting for this property unless instructed to by Teledyne API's Technical Support
personnel.
It is recommended that you check these settings the first time you power up your analyzer after it
has been physically connected to the LAN/Internet to make sure that the DHCP has successfully
downloaded the appropriate information from you network server(s).
If the gateway IP, instrument IP and the subnet mask are all zeroes (e.g. "0.0.0.0"), the DCHP was
You may have to manually configure the analyzer's Ethernet properties.
07272B DCN6552
This displays whether the DHCP is turned ON or OFF.
ON
Press EDIT and toggle ON for automatic configuration
after first consulting network administrator. (
This string of four packets of 1 to 3 numbers each (e.g.
192.168.76.55.) is the address of the analyzer itself.
Can only be edited when DHCP is set to OFF.
0.0.0.0
A string of numbers very similar to the Instrument IP
address (e.g. 192.168.76.1.) that is the address of the
computer used by your LA To access the Internet.
Can only be edited when DHCP is set to OFF.
Also a string of four packets of 1 to 3 numbers each (e.g.
255.255.252.0) that identifies the LA To which the device
is connected.
0.0.0.0
All addressable devices and computers on a LAN must
have the same subnet mask. Any transmissions sent to
devices with different subnets are assumed to be outside
of the LAN and are routed through the gateway computer
onto the Internet.
This number defines the terminal control port by which the
3000
instrument is addressed by terminal emulation software,
such as Internet or Teledyne API's APICOM.
The name by which your analyzer will appear when
T100
addressed from other computers on the LAN or via the
Internet. To change, see Section 4.11.6.3.
NOTE
not successful.
See your network administrator.
Operating Instructions
DESCRIPTION
115