Teledyne T360 Operation Manual page 165

Teledyne API Model T360/T360M Operation Manual
4.15.4.3. ACTIVATING HESSEN PROTOCOL
SAMPLE*
Repeat the entire
process to set up < TST TST > CAL
the COM2 port
SETUP X.X
CFG DAS RNGE PASS CLK
SETUP X.X
COMM
SETUP X.X
Select which COMM
port to configure
ID INET
The sum of the mode
SETUP X.X
IDs of the selected
modes is displayed here
SET>
07272B DCN6552
The first step in configuring the T360 to operate over a Hessen protocol network
is to activate the Hessen mode for com ports and configure the communication
parameters for the port(s) appropriately. Press:
RANGE = 500.000 PPM CO2 =X.XXX
SETUP
PRIMARY SETUP MENU
MORE EXIT
SECONDARY SETUP MENU
VARS DIAG ALRM EXIT
COMMUNICATIONS MENU
COM1 COM2 EXIT
COM1 MODE:0
EDIT EXIT
SETUP X.X COM1 QUIET MODE: OFF
NEXT OFF ENTR EXIT
Continue pressing next until ...
SETUP X.X COM1 HESSEN PROTOCOL : OFF
PREV NEXT OFF ENTR EXIT
SETUP X.X COM1 HESSEN PROTOCOL : ON
PREV NEXT ON ENTR EXIT
SETUP X.X COM1 E,7,1 MODE: OFF
PREV NEXT OFF ENTR EXIT
SETUP X.X COM1 E,7,1 MODE: ON
PREV NEXT ON ENTR EXIT
Operating Instructions
Toggle OFF/ON to
change
activate/deactivate
selected mode.
ENTR accepts the new
settings
EXIT ignores the new
settings
163