Pneumatic Connections; Basic Pneumatic Connections - Teledyne T360 Operation Manual

Getting Started

3.6. PNEUMATIC CONNECTIONS

3.6.1. Basic Pneumatic Connections

In order to prevent dust from getting into the gas flow channels of your analyzer, it was shipped
with small plugs inserted into each of the pneumatic fittings on the back panel. Remove these
plugs before operating the analyzer. It is recommended that they be stored for future use (moving,
Sample and calibration gases should only come into contact with PTFE (Teflon), FEP, glass,
44
Do not operate this instrument until you've removed dust plugs from SAMPLE
and EXHAUST ports on the rear panel!
storing or shipping the analyzer).
Figure 3-11 illustrates the internal gas flow of the instrument in its basic
configuration. Figure 3-13 illustrates the basic configuration for gas supply and
exhaust lines to the Model T360 Analyzer.
Please refer to Figure 3-4 for pneumatic fittings at the rear panel and Table 3-2
for their descriptions.
stainless steel or brass.
Teledyne API Model T360/T360M Operation Manual
CAUTION!
NOTE
NOTE
07272B DCN6552