Teledyne T360 Operation Manual page 123

Teledyne API Model T360/T360M Operation Manual
07272B DCN6552
5. In the instrument's SETUP>MORE>COMM>COM2 menu, make the following
settings:
B
aud Rate: 115200
COM2 Mode Settings:
Quiet Mode
Computer Mode
MODBUS RTU
MODBUS ASCII
E,8,1 MODE
E,7,1 MODE
RS-485 MODE
SECURITY MODE
MULTIDROP MODE
ENABLE MODEM
ERROR CHECKING
XON/XOFF HANDSHAKE
HARDWARE HANDSHAKE OFF
HARDWARE FIFO
COMMAND PROMPT
6. Next, configure your communications software, such as APIcom. Use the
COM port determined in Step 4 and the baud rate set in Step 5. The figures
below show how these parameters would be configured in the Instrument
Properties window in APIcom when configuring a new instrument. See the
APIcom manual (PN 07463) for more details.
Note that USB configuration requires that baud rate (Section 4.11.10) of
instrument and PC match. Also, using the USB port disallows use of the rear
panel COM2 port except for multidrop communications (Section 4.11.8).
ON
ON
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
ON
OFF
ON
OFF
Operating Instructions
121