Chrysler Concorde 2004 Service Manual page 577

Verification Tests —
SPEED PRO STEERING VERIFICATION TEST - VER 1
1. Connect all previously disconnected components and connectors.
2. With the DRBIII , erase DTC's.
3. Cycle the ignition switch from off to on.
4. With the DRBIII , read DTC's. If any DTCs are present return to the Symptom List and
perform the appropriate diagnostic procedure. If no DTCs are present, road test the vehicle for
at least 15 minutes performing several steering maneuvers.
5. Again with the DRBIII , read DTC's. If any DTCs are present select the appropriate
symptom from the Symptom List and perform the appropriate diagnostic procedure.
6. If no DTCs are present and the customers complaint cannot be duplicated, the repair is
complete.
Were there any DTCs set during the road test?
Yes → Repair is not complete, refer to appropriate symptom.
→ Repair is complete.
No
TIRE PRESSURE VERIFICATION TEST
1. Perform the EVIC training as instructed in the System Description.
2. Using the DRBIII or the EVIC RESET button, set the EVIC to Diagnostics mode (blank
screen).
3. NOTE: Set the EVIC as follows:
4. Press and hold the EVIC RESET button for five seconds (EVIC will beep).
5. Set the EVIC to display BLOCK COUNTERS.
6. NOTE: A vehicle graphic will display showing counters at wheel locations.
7. Drive the vehicle at 40 km/h (25 mph) for at least 2 minutes.
8. Observe that the counters increment at least 3 sensor/transmitter receptions for each wheel.
Can the EVIC be trained and do the counters show Sensor/Transmitter receptions?
Yes → Repair is complete.
→ Refer to Diagnosing System Faults in the Description and Operation for
No
this system.
1. Ensure all doors and the decklid are closed.
2. Open the driver door.
3. Remove the ignition key (but keep in hand).
4. Lock the doors with RKE transmitter.
5. Close the driver door.
6. - If the VTSS Indicator Lamp flashes rapidly and after approximately 15 seconds changes to
a slower flash, the system is operational.
7. - If the Indicator fails to flash as described, there is a problem with the system. Select the
Identifying VTSS symptom from the Symptom List to troubleshoot.
Are any DTC's present or is the original complaint still present?
Yes → Repair is not complete, refer to the appropriate symptom.
→ Repair is complete.
No
Continued
VTSS VERIFICATION TEST - 1A
VERIFICATION TESTS
561
APPLICABILITY
All
APPLICABILITY
All
APPLICABILITY
All