AUDIO
ANTENNA NOT CONNECTED - SDARS —
TEST
4
Turn the ignition off.
Disconnect the Satellite Receiver Antenna connector.
Disconnect the Satellite Receiver Module harness connectors.
Measure the resistance between ground and the Satellite Signal circuit.
Is the resistance below 5.0 ohms?
Yes → Repair the Satellite Signal circuit for a short to ground.
→ Go To 5
No
5
Turn the ignition off.
Check the antenna for physical damage.
Disconnect the Satellite Receiver Antenna connector.
Disconnect the Satellite Receiver Module harness connectors.
NOTE: Check the related wiring terminals for corrosion, damage or termi-
nal push out. Repair as necessary.
Using the schematics as a guide, inspect the wire harness and connectors. Pay
particular attention to all Power and Ground circuits.
Replace the Satellite Receiver Antenna in accordance with the service information.
Turn the ignition and the radio on and place the radio in Satellite mode.
Does the DTC return?
Yes → Go To 6
→ Repair is complete.
No
6
NOTE: Disconnect the Satellite Receiver Module harness connectors and
check the related wiring terminals for corrosion, damage or terminal push
out. Repair as necessary.
Using the schematics as a guide, inspect the wire harness and connectors. Pay
particular attention to all Power and Ground circuits.
If there are no possible causes remaining, view repair.
Repair
ACTION
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
Replace the Satellite Receiver Module in accordance with the
Service Information.
Perform BODY VERIFICATION TEST - VER 1.
Continued
6
APPLICABILITY
All
All
All