EXTERIOR LIGHTING
*HIGH BEAM HEADLAMPS WILL NOT TURN ON —
TEST
10
Disconnect the Multifunction Switch connector.
Turn the headlamps on.
Ensure the High Beam Relay is installed.
Connect a jumper wire between the Fused Low Beam Relay Output and the Switched
High Beam Relay Control circuits in the multifunction switch connector.
Did the High Beam Headlamps come on?
Yes → Repair the open Switched High Beam Relay Control circuit.
→ Replace the Multifunction Switch.
No
ACTION
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
234
Continued
APPLICABILITY
All