Chrysler Concorde 2004 Service Manual page 303

COMMON OUTPUT SHORTED TO GROUND —
TEST
3 Disconnect the Body Control Module C1 harness connector.
Disconnect the Blend Door Actuator harness connector.
Measure the resistance between the Common Door Driver circuit and the Sensor
Ground circuit in the BCM C1 connector.
Is the resistance below 5.0 ohms?
Yes → Go To 4
→ Replace the Blend Door Actuator.
No
4 Disconnect the Body Control Module C1 harness connector.
Disconnect the Mode Door Actuator harness connector.
Measure the resistance between the Common Door Driver circuit and the Sensor
Ground circuit in the BCM C1 connector.
Is the resistance below 5.0 ohms?
Yes → Repair the Common Door Driver circuit for a short to the Sensor
→ Replace the Mode Door Actuator.
No
ACTION
Calibration must be performed after repair/replacement is com-
pleted.
Perform BODY VERIFICATION TEST - VER 1.
Ground circuit.
Calibration must be performed after repair/replacement is com-
pleted.
Perform BODY VERIFICATION TEST - VER 1.
Calibration must be performed after repair/replacement is com-
pleted.
Perform BODY VERIFICATION TEST - VER 1.
Continued
287
HEATING & A/C
APPLICABILITY
All
All