Chrysler Concorde 2004 Service Manual page 222

ELECTRICALLY HEATED SYSTEMS
PASSENGER SEAT HEAT OUTPUT OPEN —
TEST
6 NOTE: Raise the seat to the highest position to gain access to the connectors. The
MHSMM is located at the front of the drivers seat and the Seat Heater connectors are
at the rear of each seat.
Disconnect the Passenger Heated Seat Back 2-way green connector.
Measure the SEAT BACK HEATER ELEMENT by connecting one lead to the Heated
Seat Driver terminal and the other to the Ground circuit in the Heated Seat Back
2-way connector, seat back side.
Is the resistance below 2.5 ohms?
Yes → Test Complete.
→ Replace the Passenger Heated Seat Back.
No
ACTION
Perform MEMORY HEATED SYSTEM VERIFICATION TEST -
VER 1.
Continued
206
APPLICABILITY
All