Chrysler Concorde 2004 Service Manual page 788

DRIVEABILITY - NGC
P0300-MULTIPLE CYLINDER MISFIRE —
TEST
11 Turn the ignition off.
Disconnect the Fuel Injector harness connector.
Disconnect the PCM harness connectors.
CAUTION: DO NOT PROBE THE PCM HARNESS CONNECTORS. PROBING
THE PCM HARNESS CONNECTORS WILL DAMAGE THE PCM TERMI-
NALS RESULTING IN POOR TERMINAL TO PIN CONNECTION. INSTALL
MILLER SPECIAL TOOL #8815 TO PERFORM DIAGNOSIS.
Check the Injector Control circuit.
Was a problem found with the Injector Control circuit?
Yes → Repair the Injector Control circuit.
→ NOTE: Before continuing, check the PCM harness connector
No
12 Turn the ignition off.
Warning: The fuel system is under a constant pressure (even with the engine
off). Before testing or servicing any fuel system hose, fitting or line, the fuel
system pressure must be released.
Raise vehicle on hoist, and disconnect the fuel pressure line at the fuel pump module.
Install special 5/16 fuel line adapter tool #6539 between the disconnected fuel line
and the fuel pump module.
Attach a fuel pressure test gauge to the T fitting on the tool #6539
Ignition on, engine not running.
With the DRBIII , actuate the ASD Fuel System test and observe the fuel pressure
gauge.
NOTE: Fuel pressure specification is 400 KPa +/- 34 KPa (58 psi +/- 5 psi).
Is the fuel pressure within specification?
Yes → Repair or replace fuel supply line as necessary.
→ Go To 13
No
13 Turn the ignition off.
Warning: The fuel system is under a constant pressure (even with the engine
off). Before testing or servicing any fuel system hose,fitting or line, the fuel
system pressure must be released.
Remove the Fuel Pump Module and inspect the Fuel Inlet Strainer.
Is the Fuel Inlet Strainer plugged?
Yes → Replace the Fuel Pump Inlet Strainer.
→ NOTE: Before continuing, check the Fuel Pump Module harness
No
ACTION
Perform POWERTRAIN VERIFICATION TEST VER - 5 - NGC.
terminals for corrosion, damage, or terminal push out. Repair as
necessary. Replace and program the Powertrain Control Module
in accordance with the Service Information.
Perform POWERTRAIN VERIFICATION TEST VER - 5 - NGC.
Perform POWERTRAIN VERIFICATION TEST VER - 5 - NGC.
Perform POWERTRAIN VERIFICATION TEST VER - 5 - NGC.
connector terminals for corrosion, damage, or terminal push out.
Ensure the ground circuit is operating properly. Repair as neces-
sary. Replace the Fuel Pump Module.
Perform POWERTRAIN VERIFICATION TEST VER - 5 - NGC.
Continued
130
APPLICABILITY
All
All
All