Chrysler Concorde 2004 Service Manual page 737

P0121-THROTTLE POSITION SENSOR #1 PERFORMANCE —
TEST
1 NOTE: Diagnose any TP Sensor or MAP Sensor component DTCs before
continuing.
NOTE: The throttle plate and linkage must be free from binding and carbon
build up.
NOTE: Ensure the throttle plate is at the idle position.
Ignition on, engine not running.
With the DRBIII , read DTCs and record the related Freeze Frame data.
Is the Good Trip Counter displayed and equal to zero?
Yes → Go To 2
→ Refer to the INTERMITTENT CONDITION symptom in the
No
2 Start the engine.
With the DRBIII , monitor the MAP Sensor voltage.
Snap the throttle.
Does the MAP Sensor voltage vary from below 2.0 volts at idle to above 3.5 volts at
WOT?
Yes → Go To 3
→ Go To 11
No
3 Ignition on, engine not running.
With the DRBIII , monitor the TP Sensor voltage while slowly depressing the
throttle pedal from the idle position to the wide open throttle position.
Does the voltage start approximately at 0.8 volts and go above 3.5 volts with a smooth
transition?
Yes → Refer to the INTERMITTENT CONDITION symptom in the
→ Go To 4
No
4 Turn the ignition off.
Disconnect the TP Sensor harness connector.
Disconnect the PCM harness connector.
CAUTION: DO NOT PROBE THE PCM HARNESS CONNECTORS. PROBING
THE PCM HARNESS CONNECTORS WILL DAMAGE THE PCM TERMI-
NALS RESULTING IN POOR TERMINAL TO PIN CONNECTION. INSTALL
MILLER SPECIAL TOOL #8815 TO PERFORM DIAGNOSIS.
Measure the resistance of the (K6) 5 Volt Supply circuit from the TP Sensor harness
connector to the appropriate terminal of special tool #8815.
Is the resistance below 5.0 ohms?
Yes → Go To 5
→ Repair the TP Sensor (K6) 5 Volt Supply circuit.
No
ACTION
Driveability category.
Perform POWERTRAIN VERIFICATION TEST VER - 5 - NGC.
Driveability category.
Perform POWERTRAIN VERIFICATION TEST VER - 5 - NGC.
Perform POWERTRAIN VERIFICATION TEST VER - 5 - NGC.
DRIVEABILITY - NGC
79
Continued
APPLICABILITY
All
All
All
All