Chrysler Concorde 2004 Service Manual page 980

VERIFICATION TESTS
Verification Tests
1. Disconnect all jumper wires and reconnect all previously disconnected components and
connectors.
2. NOTE: If the SKIM or PCM was replaced, refer to the service information for
proper programming procedures.
3. If the Body Control Module was replaced, turn the ignition on for 15 seconds (to allow the new
BCM to learn VIN) or engine may not start (if VTSS equipped). If the vehicle is equipped with
VTSS, use the DRBIII and enable VTSS.
4. Program all RKE transmitters and other options as necessary.
5. If any repairs were made to the HVAC System, either disconnect the battery or remove JB
Fuse #19 for five minutes to calibrate the HVAC doors.
6. Ensure that all accessories are turned off and the battery is fully charged.
7. With the DRBIII , record and erase all DTC's from ALL modules. Start and run the engine
for 2 minutes. Operate all functions of the system that caused the original concern.
8. Turn the ignition off and wait 5 seconds. Turn the ignition on and using the DRBIII , read
DTC's from ALL modules.
Are any DTC's present or is the original condition still present?
Yes → Repair is not complete, refer to the appropriate symptom.
→ Repair is complete.
No
POWERTRAIN VERIFICATION TEST VER - 1
1. NOTE: After completing the Powertrain Verification Test the Transmission Verifi-
cation Test must be performed.
2. NOTE: If the PCM has been replaced and the correct VIN and mileage have not
been programmed, a DTC will be set in the ABS Module, Airbag Module and the
SKIM.
3. NOTE: If the vehicle is equipped with a Sentry Key Immobilizer System, Secret Key
data must be updated. Refer to the Service Information for the PCM, SKIM and the
Transponder (ignition key) for programming information.
4. Inspect the vehicle to ensure that all components related to the repair are connected properly.
5. Inspect the engine oil for fuel contamination. Replace the oil and filter as necessary.
6. Attempt to start the engine.
7. If the No Start condition is still present, refer to the symptom list and perform the diagnostic
testing as necessary. refer to any Technical Service Bulletins that may apply.
8. Run the engine for one warm-up cycle to verify operation.
9. With the DRBIII , confirm that no DTCs or Secondary Indicators are present and that all
components are functioning properly.
10. If a DTC is present, refer to the appropriate category and select the corresponding symptom.
Are any DTCs present?
Yes → Repair is not complete, refer to appropriate symptom.
→ Repair is complete.
No
BODY VERIFICATION TEST - VER 1
322
APPLICABILITY
All
APPLICABILITY
All