Chrysler Concorde 2004 Service Manual page 449

Symptom:
PASSENGER MIRROR HORIZONTAL SENSOR OUT OF RANGE
HIGH (IF EQUIPPED)
When Monitored and Set Condition:
PASSENGER MIRROR HORIZONTAL SENSOR OUT OF RANGE HIGH (IF
EQUIPPED)
When Monitored: Ignition on.
Set Condition: This code is set when the mirror sensor feedback to the MHSMM is
greater than the mirror out of range high value stored in EEPROM.
PASSENGER MIRROR HORIZONTAL POSITION SIGNAL WIRE SHORT TO VOLTAGE
PASSENGER MEMORY MIRROR
MEMORY HEATED SEAT MIRROR MODULE
TEST
1 Turn the ignition on.
Disconnect the Memory Heated Seat Mirror Module C1 connector.
Measure the voltage of the Passenger Mirror Horizontal Position Signal circuit.
Is the voltage above 4.5 volts?
Yes → Go To 2
→ Replace the Memory Heated Seat Mirror Module.
No
2 Disconnect the Memory Heated Seat Mirror Module C1 connector.
Disconnect the Passenger Power Mirror connector.
Turn the ignition on.
Measure the voltage of the Passenger Horizontal Position Signal circuit in the
passenger power mirror harness side connector.
Is there any voltage present?
Yes → Repair the Passenger Mirror Horizontal Position Signal wire for a
→ Go To 3
No
3 If there are no possible causes remaining, view repair.
Repair
POSSIBLE CAUSES
ACTION
Perform MEMORY HEATED SYSTEM VERIFICATION TEST -
VER 1.
short to voltage.
Perform MEMORY HEATED SYSTEM VERIFICATION TEST -
VER 1.
If there are no possible causes remaining, replace the Passenger
Memory Mirror.
Perform MEMORY HEATED SYSTEM VERIFICATION TEST -
VER 1.
433
MEMORY SEAT
APPLICABILITY
All
All
All