Chrysler Concorde 2004 Service Manual page 518

POWER DOOR LOCKS/RKE
*DOOR LOCK INHIBIT INOPERATIVE —
TEST
4 Turn the ignition off.
Disconnect the Ignition Switch harness connector.
Turn all lights off.
Measure the resistance between ground and the ground circuit in the ignition switch
connector.
Is the resistance below 5.0 ohms?
Yes → Go To 5
→ Repair the ground circuit for an open.
No
5 Turn the ignition off.
Disconnect the Ignition Switch harness connector.
Disconnect the Body Control Module C2 harness connector.
Measure the resistance of the Key-In Ignition Switch Sense circuit between the
ignition switch connector and the BCM C2 connector.
Is the resistance below 5.0 ohms?
Yes → Go To 6
→ Repair the Key-In Ignition Switch Sense circuit for an open.
No
6 If there are no possible causes remaining, view repair.
Repair
ACTION
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
Replace the Body Control Module.
Perform BODY VERIFICATION TEST - VER 1.
Continued
502
APPLICABILITY
All
All
All