Chrysler Concorde 2004 Service Manual page 909

Symptom:
P0632-ODOMETER NOT PROGRAMMED IN PCM
When Monitored and Set Condition:
P0632-ODOMETER NOT PROGRAMMED IN PCM
When Monitored: Ignition on.
Set Condition: The mileage has not been programmed into the PCM.
PROGRAMMING MILEAGE INTO PCM
VERIFY PCM PROGRAMMING
PCM
TEST
1 Ignition on, engine not running.
With the DRBIII , erase DTCs.
Using the DRBIII , program the mileage into the PCM.
Start the engine.
Allow the engine to reach normal operating temperature.
With the DRBIII , read DTCs.
Does the DTC reset?
Yes → Go To 2
→ The mileage has been succcessfully programmed into the PCM.
No
2 NOTE: The ignition switch must be left in the off position for a minimum of
10 seconds.
Cycle the ignition switch to the off position and then back to run.
Attempt to program the PCM with the applicable information.
Start the vehicle and allow it to reach normal operating temperatures.
With the DRBIII , read DTCs.
Does the DTC reset?
Yes → Replace and program the Powertrain Control Module in accor-
→ The mileage has been successfully programmed into the PCM.
No
POSSIBLE CAUSES
ACTION
Test is complete.
Perform POWERTRAIN VERIFICATION TEST VER - 1.
dance with the Service Information.
Perform POWERTRAIN VERIFICATION TEST VER - 1.
Test is complete.
Perform POWERTRAIN VERIFICATION TEST VER - 1.
DRIVEABILITY - NGC
251
APPLICABILITY
All
All