Chrysler Concorde 2004 Service Manual page 212

Hide thumbs Also See for Concorde 2004:

Table of Contents

ELECTRICALLY HEATED SYSTEMS

DRIVER THERMISTOR OUT OF RANGE HIGH —

If there are no possible causes remaining, view Repair .

NOTE: Raise the seat to the highest position to gain access to the connectors. The

MHSMM is located at the front of the seat and the Seat Heater connectors are at the

rear of the seat.

Disconnect the Driver Heated Seat Cushion 4-way connector.

Disconnect the Memory Heated Seat Mirror Module C1 connector.

Turn ignition on.

Measure the voltage between Driver Seat Temperature Sensor Input circuit and

Is there ANY voltage on the Driver Seat Temperature Sensor Input circuit?

Yes → Repair the Driver Seat Temperature Sensor Input circuit for a

If there are no possible causes remaining, view repair.

Replace the Memory Heated Seat Mirror Module

Perform MEMORY HEATED SYSTEM VERIFICATION TEST -

short to voltage.

Perform MEMORY HEATED SYSTEM VERIFICATION TEST -

Replace the Driver Seat Cushion.

Perform MEMORY HEATED SYSTEM VERIFICATION TEST -

APPLICABILITY

Chapters

Table of Contents

300m 2004 Intrepid 2004