AUDIO
Symptom:
NO COMMUNICATION WITH SDARS
When Monitored and Set Condition:
NO COMMUNICATION WITH SDARS
When Monitored: With the ignition on.
Set Condition: When the radio fails it's phase 1 recovery stage.
ATTEMPT TO COMMUNICATE WITH THE SATELLITE RADIO RECEIVER MODULE
RADIO
TEST
1
Turn the ignition on.
Turn the Radio on and place the Radio in Satellite mode.
With the DRB, attempt to communicate with the Satellite Radio Receiver Module.
Was the DRB able to I/D or communicate with the module?
Yes → Go To 2
→ Refer to the Communication category for the related symptom(s).
No
2
With the DRB, erase DTC's.
Turn the ignition on.
Turn the Radio on and place the Radio in Satellite mode and wait approximately 1
minute.
With the DRB, read DTC's.
Did this DTC reset?
Yes → Replace the Radio in accordance with the service information.
→ Test Complete.
No
POSSIBLE CAUSES
ACTION
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
18
APPLICABILITY
All
All