Chrysler Concorde 2004 Service Manual page 194

COMMUNICATION
*PCI BUS COMMUNICATION FAILURE —
TEST
7 Note: Determine which modules this vehicle is equipped with before begin-
ning.
Turn the ignition off.
Disconnect the negative battery cable.
Disconnect the BCM harness connectors and remove the Body Control Module from
the Junction Block.
Measure the resistance between ground and each of the PCI Bus circuits at the BCM
C1, C3, C4 connectors and at the Junction Block Body Control Module connector
cavity 10.
Is the resistance below 1000.0 ohms for any of the measurements?
Yes → Go To 8
→ Replace the Body Control Module in accordance with the service
No
8 Turn the ignition off.
Disconnect the negative battery cable.
Disconnect the module that corresponds to the PCI Bus circuit that resistance
measured below 1000.0 ohms.
NOTE: If the PCI Bus circuit for the Memory Heated Seat/Mirror Module
was below 1000.0 ohms and is equipped with side airbags, disconnect each
module one at a time.
NOTE: If the PCI Bus circuit for the Radio was below 1000.0 ohms and is
equipped with a CD Changer, disconnect the CD Changer before the Radio.
Measure the resistance between ground and the PCI Bus circuit that previously
measured below 1000.0 ohms.
Is the resistance below 1000.0 ohms with the module disconnected?
Yes → Repair the PCI Bus circuit that resistance measured below 1000.0
→ Replace the module that caused the short to ground on the PCI
No
ACTION
information.
Perform BODY VERIFICATION TEST - VER 1.
ohms for a short to ground.
Perform BODY VERIFICATION TEST - VER 1.
Bus circuit.
Perform BODY VERIFICATION TEST - VER 1.
Continued
178
APPLICABILITY
All
All