Chrysler Concorde 2004 Service Manual page 416

INTERIOR LIGHTING
*COURTESY LAMPS STAY ON AT ALL TIMES —
TEST
4 Ensure the Courtesy Lamp Switch is off.
Close all the passenger doors.
Close the Driver Door Lock Latch Assembly.
Disconnect the Junction Block C11 connector from the front of the junction block.
Observe the Door Courtesy Lamps.
Did the Door Courtesy Lamps turn off?
Yes → Repair the Courtesy Lamps Driver circuit in the Body Harness for
→ Go To 5
No
5 Close all the passenger doors.
With the DRBIII select: Body, Body Computer, Input/Output
Read the: Door Ajar Switch - state
Gain access to and disconnect each passenger Door Lock Motor/Ajar switch and
observe the DRBIII .
When disconnecting each switch, did the DRBIII change states to read: Door Ajar
Sw - OPEN?
Yes → Replace the applicable Door Lock Motor /Ajar switch.
→ Go To 6
No
6 Disconnect the Body Control Module C4 connector.
Gain access to and disconnect all passenger Door Lock Motor/Ajar switch connectors.
Measure the resistance of each passenger Door Ajar Switch Sense circuits in the Body
Control Module C4 connector to ground.
Is the resistance below 1000.0 ohms in any of the passenger Door Ajar Switch Sense
circuits?
Yes → Using the schematic, determine which door ajar switch sense
→ Go To 7
No
7 Turn the ignition off.
Remove the driver inner door panel.
Disconnect the Driver Door Lock Motor/Ajar Switch connector
Disconnect the Body Control Module C4 connector.
Measure the resistance or the Driver Door Ajar Switch Sense circuit at the Body
Control Module C4 connector to ground.
Is the resistance below 5.0 ohms?
Yes → Repair the Driver Door Ajar Switch Sense circuit for a short to
→ Go To 8
No
ACTION
a short to ground.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
circuit is shorted to ground and repair as necessary.
Perform BODY VERIFICATION TEST - VER 1.
ground.
Perform BODY VERIFICATION TEST - VER 1.
Continued
400
APPLICABILITY
All
All
All
All