Chrysler Concorde 2004 Service Manual page 817

Hide thumbs Also See for Concorde 2004:

Table of Contents

P0351-IGNITION COIL #1 CIRCUIT —

Turn the ignition off.

Disconnect the Ignition Coil harness connector.

Remove the ASD Relay from the PDC.

Measure the resistance of the ASD Relay Output circuit between the ASD Relay

connector and the Ignition Coil harness connector.

Is the resistance below 5.0 ohms?

Yes → Go To 8

→ Repair the open in the ASD Relay Output circuit.

NOTE: Repeat the following test for both capacitors

NOTE: The Capacitors are attached to the side of each valve cover.

Turn the ignition off.

Disconnect the Capacitor harness connector.

Install a good INJ/COIL fuse.

With the DRBIII , actuate the ASD Relay.

NOTE: If the above test result is an open fuse for both capacitor tests, the

problem is a short to ground in the ASD Relay Output circuit. Repair the

short to ground in the ASD Relay Output circuit and refer to VER-5

Is the INJ/COIL fuse OK for both capacitor tests?

Yes → Replace the Capacitor(s)

→ Repair the ASD Output circuit for a short to ground.

Perform POWERTRAIN VERIFICATION TEST VER - 5 - NGC.

DRIVEABILITY - NGC

APPLICABILITY

Chapters

Table of Contents

300m 2004 Intrepid 2004