Chrysler Concorde 2004 Service Manual page 771

Hide thumbs Also See for Concorde 2004:
Table of Contents

Advertisement

P0171-FUEL SYSTEM 1/1 LEAN —
TEST
1
NOTE: Check for contaminates that may have damaged the O2 Sensor:
contaminated fuel, unapproved silicone, oil and coolant.
NOTE: Diagnose any Misfire DTC(s) first, if set along with the fuel system
DTC.
Ignition on, engine not running.
With the DRBIII , read DTCs and record the related Freeze Frame data.
Is the Good Trip Counter displayed and equal to zero?
Yes → Go To 2
→ Refer to the INTERMITTENT CONDITION symptom in the
No
2
Warning: The fuel system is under a constant pressure (even with the engine
off). Before testing or servicing any fuel system hose, fitting or line, the fuel
system pressure must be released.
Install a fuel pressure gauge.
Ignition on, engine not running.
With the DRBIII , actuate the ASD Fuel System test and observe the fuel pressure
gauge.
NOTE: Fuel pressure specification is 400 KPa +/- 34 KPa (58 psi +/- 5 psi).
Turn the ignition off.
Choose a conclusion that best matches your fuel pressure reading.
Within Specification
Below Specification
Caution: Stop All Actuations.
3
NOTE: If one of the O2 Sensors Signal or Return circuits are shorted to
ground or voltage, all the other O2 Sensor voltage readings will be affected.
NOTE: After the repairs have been made, verify proper O2 Sensor operation.
If all the O2 Sensor voltage readings have not returned to normal, follow the
diagnostic procedure for the remaining O2 Sensors.
Start the engine.
Allow the engine to reach normal operating temperature.
With the DRBIII , read the O2 Sensor voltage.
Is the voltage switching between 2.5 and 3.4 volts?
Yes → Go To 4
→ Go To 9
No
4
Turn the ignition off.
NOTE: Allow the O2 Sensor to cool down before continuing the test. The O2
voltage should stabilize at 5.0 volts. Raising the hood may help in reducing
under hood temps.
Ignition on, engine not running.
With the DRBIII , actuate the O2 Heater Test.
With the DRBIII , monitor O2 Sensor voltage for at least 2 minutes.
Does the voltage stay above 4.5 volts?
Yes → Replace the O2 Sensor.
→ Go To 5
No
ACTION
Driveability category.
Perform POWERTRAIN VERIFICATION TEST VER - 5 - NGC.
Go To 3
Go To 12
Perform POWERTRAIN VERIFICATION TEST VER - 5 - NGC.
DRIVEABILITY - NGC
Continued
113
APPLICABILITY
All
All
All
All

Advertisement

Table of Contents
loading

This manual is also suitable for:

300m 2004Intrepid 2004

Table of Contents