Chrysler Concorde 2004 Service Manual page 575

Verification Tests —
1. Disconnect all jumper wires and reconnect all previously disconnected components and
connectors.
2. NOTE: If the SKIM or PCM was replaced, refer to the service information for
proper programming procedures.
3. If the Body Control Module was replaced, turn the ignition on for 15 seconds (to allow the new
BCM to learn VIN) or engine may not start (if VTSS equipped). If the vehicle is equipped with
VTSS, use the DRBIII and enable VTSS.
4. Program all RKE transmitters and other options as necessary.
5. If any repairs were made to the HVAC System, either disconnect the battery or remove JB
Fuse #19 for five minutes to calibrate the HVAC doors.
6. Ensure that all accessories are turned off and the battery is fully charged.
7. With the DRBIII , record and erase all DTC's from ALL modules. Start and run the engine
for 2 minutes. Operate all functions of the system that caused the original concern.
8. Turn the ignition off and wait 5 seconds. Turn the ignition on and using the DRBIII , read
DTC's from ALL modules.
Are any DTC's present or is the original condition still present?
Yes → Repair is not complete, refer to the appropriate symptom.
→ Repair is complete.
No
MEMORY HEATED SYSTEM VERIFICATION TEST - VER 1
1. Reconnect all previously disconnected components and connectors.
2. If any Memory Heated Seat Memory Module Trouble Codes are present, erase at this time.
3. If the Memory Seat Module was replaced, use the DRBIII and Reset Guard Bands.
4. With the Memory Switch on the Driver's Door, program the Driver's Seat #1 Button to a
desired position and Driver #2 Button to a different position.
5. Remove the Ignition Key and close all Doors to allow the Body Control Module to time out,
about 30 seconds.
6. Verify that both Memory positions can be recalled from the RKE transmitter and the Memory
Switch on the Driver's Door.
7. Turn the ignition on, and with the DRBIII, erase all Diagnostic Trouble Codes from ALL
modules. Start the engine and allow it to run for 2 minutes and fully operate the system that
was malfunctioning.
8. Turn the ignition off and wait 5 seconds. Turn the ignition on and using the DRBIII, read
DTC's from ALL modules.
Are any DTC's present or is the original complaint still present?
Yes → Repair is not complete, refer to appropriate symptom.
→ Repair is complete.
No
Continued
BODY VERIFICATION TEST - VER 1
VERIFICATION TESTS
559
APPLICABILITY
All
APPLICABILITY
All