Chrysler Concorde 2004 Service Manual page 99

SEAT SQUIB CIRCUIT SHORT —
TEST
2 WARNING: TURN THE IGNITION OFF, DISCONNECT THE BATTERY AND
WAIT TWO MINUTES BEFORE PROCEEDING.
WARNING: DO NOT PLACE AN INTACT UNDEPLOYED SEAT BACK PAD-
DED SIDE DOWN ON A HARD SURFACE, THE AIRBAG WILL PROPEL
INTO THE AIR IF ACCIDENTALLY DEPLOYED, AND COULD RESULT IN
SERIOUS OR FATAL INJURY.
Disconnect the Seat Airbag connector.
NOTE: Check connectors - Clean repair as necessary.
Connect the appropriate Load Tool to the Seat Airbag connector.
WARNING: TURN IGNITION ON, THEN RECONNECT THE BATTERY.
With the DRB, read the SIACM active DTC's.
Does the DRB show SEAT SQUIB CIRCUIT SHORT?
Yes → Go To 3
→ Replace Seat Airbag in accordance with the Service Information.
No
3 WARNING: TURN THE IGNITION OFF, DISCONNECT THE BATTERY AND
WAIT TWO MINUTES BEFORE PROCEEDING.
WARNING: DO NOT PLACE AN INTACT UNDEPLOYED SEAT BACK PAD-
DED SIDE DOWN ON A HARD SURFACE, THE AIRBAG WILL PROPEL
INTO THE AIR IF ACCIDENTALLY DEPLOYED, AND COULD RESULT IN
SERIOUS OR FATAL INJURY.
NOTE: Check connectors - Clean and repair as necessary.
Connect the appropriate Load Tool adaptor to the SIACM connector.
Disconnect the Side Impact Airbag Control Module connector
Measure the resistance between the Seat Squib 1 Line 1 and Line 2 circuits at the
Seat Airbag connector.
Is the resistance below 10K ohms?
Yes → Repair Seat Squib 1 Line 1 shorted to Line 2 circuit.
→ Replace the Side Impact Airbag Control Module in accordance
No
Continued
ACTION
Perform AIRBAG VERIFICATION TEST - VER 1.
Perform AIRBAG VERIFICATION TEST - VER 1.
with Service Instructions. WARNING: IF THE SIDE IMPACT
AIRBAG CONTROL MODULE IS DROPPED AT ANY TIME, IT
MUST BE REPLACED.
Perform AIRBAG VERIFICATION TEST - VER 1.
83
AIRBAG
APPLICABILITY
All
All