Chrysler Concorde 2004 Service Manual page 452

MEMORY SEAT
Symptom:
PASSENGER MIRROR VERTICAL SENSOR OUT OF RANGE HIGH
(IF EQUIPPED)
When Monitored and Set Condition:
PASSENGER MIRROR VERTICAL SENSOR OUT OF RANGE HIGH (IF
EQUIPPED)
When Monitored: Ignition on.
Set Condition: This code is set when the mirror sensor feedback to the MHSMM is
greater than the mirror out of range high value stored in EEPROM.
PASSENGER MIRROR VERTICAL POSITION SIGNAL WIRE SHORT TO VOLTAGE
PASSENGER MEMORY MIRROR
MEMORY HEATED SEAT MIRROR MODULE
TEST
1 Turn the ignition on.
Disconnect the Memory Heated Seat Mirror Module C1 connector.
Measure the voltage of the Passenger Mirror Vertical Position Signal circuit.
Is the voltage above 4.5 volts?
Yes → Go To 2
→ Replace the Memory Heated Seat Mirror Module.
No
2 Disconnect the Memory Heated Seat Mirror Module C1 connector.
Disconnect the Passenger Power Mirror connector.
Turn the ignition on.
Measure the voltage of the Passenger Vertical Position Signal circuit in the
passenger power mirror harness side connector.
Is there any voltage present?
Yes → Repair the Passenger Mirror Vertical Position Signal wire for a
→ Go To 3
No
3 If there are no possible causes remaining, view repair.
Repair
POSSIBLE CAUSES
ACTION
Perform MEMORY HEATED SYSTEM VERIFICATION TEST -
VER 1.
short to voltage.
Perform MEMORY HEATED SYSTEM VERIFICATION TEST -
VER 1.
Replace the Passenger Memory Mirror.
Perform MEMORY HEATED SYSTEM VERIFICATION TEST -
VER 1.
436
APPLICABILITY
All
All
All