Chrysler Concorde 2004 Service Manual page 749

Hide thumbs Also See for Concorde 2004:
Table of Contents

Advertisement

P0125-INSUFFICIENT COOLANT TEMP FOR CLOSED-LOOP FUEL CON -
TROL —
Continued
TEST
2
NOTE: This test works best if performed on a cold engine (cold soak).
Ignition on, engine not running.
With the DRBIII , read the ECT Deg value. If the engine was allowed to sit overnight
(cold soak), the temperature value should be a sensible value that is somewhere close
to the ambient temperature.
Note: If engine coolant temperature is above 82°C (180°F), allow the engine
to cool until 65°C (150°F) is reached.
Start the Engine.
During engine warm-up, monitor the ECT Deg value. The temp deg value change
should be a smooth transition from start up to normal operating temp 82°C (180°F)
. Also monitor the actual coolant temperature with a thermometer.
NOTE: As the engine warms up to operating temperature, the actual coolant
temperature (thermometer reading) and the ECT Deg in the DRB sensor
should stay relatively close to each other.
Using the appropriate service information, determine the proper opening tempera-
ture of the thermostat.
Did the thermostat open at the proper temperature?
Yes → Go To 3
→ Replace the thermostat.
No
3
Ignition on, engine not running.
With the DRBIII , read the ECT Sensor temperature value. If the engine was
allowed to sit overnight (cold soak), the temperature value should be a sensible value
that is somewhere close to the ambient temperature.
Note: If engine coolant temperature is above 82°C (180°F), allow the engine
to cool until 65°C (150°F) is reached.
Start the Engine.
During engine warm-up, monitor the ECT Deg value. The temp deg value change
should be a smooth transition from start up to normal operating temp 82°C (180°F)
. Also monitor the actual coolant temperature with a thermometer.
NOTE: As the engine warms up to operating temperature, the actual coolant
temperature (thermometer reading) and the ECT Sensor Temperature in
the DRBIII sensors should stay relatively close to each other.
Is the thermometer reading relatively close to the DRBIII ECT Sensor reading?
Yes → Test Complete.
→ Replace the Engine Coolant Temperature Sensor.
No
ACTION
Perform POWERTRAIN VERIFICATION TEST VER - 5 - NGC.
Perform POWERTRAIN VERIFICATION TEST VER - 5 - NGC.
DRIVEABILITY - NGC
91
APPLICABILITY
All
All

Advertisement

Table of Contents
loading

This manual is also suitable for:

300m 2004Intrepid 2004

Table of Contents