Chrysler Concorde 2004 Service Manual page 938

Hide thumbs Also See for Concorde 2004:

Table of Contents

DRIVEABILITY - NGC

P1695-NO BODY BUS MESSAGES —

Turn the ignition off.

Disconnect the PCM harness connector

Disconnect the BCM harness connector.

NOTE: Inspect the PCI Bus terminal at both the PCM connectors and the

BCM connectors. Check for corrosion, damage or terminal push out.

CAUTION: DO NOT PROBE THE PCM HARNESS CONNECTORS. PROBING

THE PCM HARNESS CONNECTORS WILL DAMAGE THE PCM TERMI-

NALS RESULTING IN POOR TERMINAL TO PIN CONNECTION. INSTALL

MILLER SPECIAL TOOL #8815 TO PERFORM DIAGNOSIS.

Measure the resistance of the PCI BUS circuit between the Special Tool #8815 and

the BCM harness connector.

Is the resistance below 5.0 ohms?

Yes → Replace and program the Powertrain Control Module in accor-

→ Repair the PCI BUS circuit for an open.

dance with the Service Information.

Perform POWERTRAIN VERIFICATION TEST VER - 1.

APPLICABILITY

Chapters

Table of Contents

300m 2004 Intrepid 2004