PASSENGER MIRROR HORIZONTAL SENSOR OUT OF RANGE LOW (IF
EQUIPPED) —
Continued
TEST
3
Turn the ignition off.
Disconnect the Memory Heated Seat Mirror Module C1 connector.
Disconnect the Passenger Power Mirror connector.
Measure the resistance of the Passenger Mirror Horizontal Position Signal circuit to
ground at the passenger power mirror harness side connector.
Is the resistance below 1000.0 ohms?
Yes → Repair the Driver Mirror Horizontal Position Signal wire for a
→ Go To 4
No
4
Turn the ignition off.
Disconnect the Passenger Power Mirror connector.
Turn the ignition on.
Measure the voltage of the 5 volt supply circuit in the Passenger power mirror
harness side connector.
Is the voltage between 4.5 and 5.0 volts?
Yes → Replace the Passenger Memory Mirror.
→ Go To 5
No
5
Turn the ignition off.
Disconnect the Passenger Power Mirror connector.
Disconnect the MHSMM C2 harness connector.
Measure the resistance of the Passenger Mirror Sensor 5 volt supply circuit between
the passenger power mirror harness side connector and the MHSMM C2 connector.
Is the resistance below 5.0 ohms?
Yes → Replace the Memory Heated Seat Mirror Module.
→ Repair the Passenger Mirror Vertical Position Signal wire for an
No
ACTION
short to ground.
Perform MEMORY HEATED SYSTEM VERIFICATION TEST -
VER 1.
Perform MEMORY HEATED SYSTEM VERIFICATION TEST -
VER 1.
Perform MEMORY HEATED SYSTEM VERIFICATION TEST -
VER 1.
open.
Perform MEMORY HEATED SYSTEM VERIFICATION TEST -
VER 1.
435
MEMORY SEAT
APPLICABILITY
All
All
All