Chrysler Concorde 2004 Service Manual page 972

Hide thumbs Also See for Concorde 2004:
Table of Contents

Advertisement

STARTING
*ENGINE CRANKS DOES NOT START —
TEST
8
Turn the ignition off.
Disconnect the fuel pump module harness connector.
Turn the ignition on.
With the DRBIII , actuate the ASD Fuel System test.
Using a 12 volt test light connected to ground, probe the Fuel Pump Relay Output
circuit at the Fuel Pump Module harness connector.
Does the test light illuminate brightly?
Yes → Go To 9
→ Go To 11
No
Caution: Stop All Actuations.
9
Turn the ignition off.
Disconnect the Fuel Pump Module harness connector.
Note: Check connectors - It is critical that the connector is free from any
signs of corrosion or deformities - Clean/repair as necessary.
Using a test light connected to battery voltage, probe the Fuel Pump ground circuit
at the Fuel Pump Module harness connector.
Does the test light illuminate brightly?
Yes → Go To 10
→ Repair the open/high resistance in the fuel pump ground circuit.
No
10
If there are no possible causes remaining, view repair.
Repair
11
Turn the ignition off.
Remove the Fuel Pump Relay from the PDC.
With a 12 volt test light connected to ground, probe the Fuel Pump Relay Fused B+
circuit at the PDC.
Does the test light illuminate?
Yes → Go To 12
→ Repair the Fuel Pump Relay Fused B+ circuit. Check for open fuse
No
12
Turn the ignition off.
Remove the Fuel Pump Relay from the PDC.
Disconnect the Fuel Pump Module harness connector.
NOTE: Check connectors - It is critical that the connector is free from any
signs of corrosion or deformities
Measure the resistance of the Fuel Pump Relay Output circuit from the relay
connector to the fuel pump module connector.
Is the resistance below 5.0 ohms?
Yes → Replace the Fuel Pump Relay.
→ Repair the open fuel pump relay output circuit.
No
ACTION
Perform POWERTRAIN VERIFICATION TEST VER - 1.
Replace the Fuel Pump Module.
Perform POWERTRAIN VERIFICATION TEST VER - 1.
in the PDC.
Perform POWERTRAIN VERIFICATION TEST VER - 1.
Perform POWERTRAIN VERIFICATION TEST VER - 1.
Perform POWERTRAIN VERIFICATION TEST VER - 1.
Continued
314
APPLICABILITY
All
All
All
All
All

Advertisement

Table of Contents
loading

This manual is also suitable for:

300m 2004Intrepid 2004

Table of Contents