Controlling The Totalizers And Inventories - Emerson Micro Motion 2700 Configuration And Use Manual

Operation
With EDD
To view the current value of the totalizers and inventories:
• For standard mass, liquid standard volume, and gas standard volume, select
Variables > Totalizer
gas standard volume, then
inventories are displayed together.
• For petroleum measurement, select
• For concentration measurement, select
With bus parameters
To view the current value of the totalizers and inventories, examine index 26 (TOT Total) of each
totalizer function block (Slots 4, 6, 7, and 8).
5.8.2

Controlling the totalizers and inventories

Specific starting, stopping, and resetting functionality depends on the tool you are using.
With the display
If the required value is shown on the display, you can use the display to start and stop all totalizers
and inventories simultaneously, or to reset individual totalizers. See the flowchart in Figure 5-4. You
cannot reset any inventories with the display.
Figure 5-4 Controlling totalizers and inventories with the display
Process variable display
Scroll
Mass total display
Select
RESET
Select
RESET YES?
Yes
Select
(1) Displayed only if configured as a display variable (see Section 4.16.6).
(2) The petroleum measurement application or concentration measurement application must be enabled.
(3) The display must be configured to allow totalizer resetting (see Section 4.16).
(4) The display must be configured to allow stopping and starting (see Section 4.16).
90
and then select
Volume
(1)
Scroll
(3)
Scroll
No
Scroll
or . (If the transmitter is configured to use
Mass Volume
will be replaced by
Device > Device > API Totalizer
Device > Device > CM Totalizer
(1)
Volume total display
(4)
STOP/START
Select
STOP/START YES?
Yes No
Select Scroll
View > Process
Gas Standard Volume
.
.
(1)(2)
API total
(1)(2)
ED total
Scroll EXIT
Model 2700 Transmitter with PROFIBUS-PA
.) Totals and