Configuring Sensor Parameters - Emerson Micro Motion 2700 Configuration And Use Manual

Configuration
4.15

Configuring sensor parameters

The sensor parameters are used to describe the sensor component of your flowmeter. These sensor
parameters are not used in transmitter processing, and are not required:
• Serial number
• Sensor material
• Liner material
• Flange
To configure the sensor parameters, refer to the flowcharts in Figure 4-16.
Figure 4-16 Configuring sensor parameters
EDD
MMI Coriolis Flow >
Transducer Block >
Device Information
Sensor Serial Number
Sensor Material
Liner Material
Flange Type
74
Bus parameters
Sensor parameters
ProLink II
ProLink >
Configuration
Sensor tab
Enter the sensor serial
number in the Sensor s/n
box
Select the sensor serial
material from the Sensor
Matl list
Block: Transducer Block 2 (Slot 12)
Index 10 (sensor serial number)
Index 13 (sensor material)
Index 14 (liner material)
Index 15 (flange type)
Select the liner material
from the Liner Matl list
Select the flange from the
Flange list
Apply
Model 2700 Transmitter with PROFIBUS-PA