Start And Stop Totalizers And Inventories; Start And Stop Totalizers And Inventories Using The Display - Emerson Micro Motion 2700 Configuration And Use Manual

Transmitter operation
7.6

Start and stop totalizers and inventories

Display
ProLink III
Field Communicator Service Tools > Variables > Totalizer Control > All Totalizers > Start Totalizers
Overview
When you start a totalizer, it tracks process measurement. In a typical application, its value
increases with flow. When you stop a totalizer, it stops tracking process measurement and
its value does not change with flow. Inventories are started and stopped automatically,
when totalizers are started and stopped.
Important
Totalizers and inventories are started or stopped as a group. When you start any totalizer, all other
totalizers and all inventories are started simultaneously. When you stop any totalizer, all other
totalizers and all inventories are stopped simultaneously. You cannot start or stop inventories
directly.
7.6.1 Start and stop totalizers and inventories using the
display
Prerequisites
•
•
Procedure
•
84
See Section 7.6.1.
Device Tools > Totalizer Control > Totalizer and Inventories > Start All Totals
Device Tools > Totalizer Control > Totalizer and Inventories > Stop All Totals
Service Tools > Variables > Totalizer Control > All Totalizers > Stop Totalizers
The Totalizer Start/Stop display function must be enabled.
At least one totalizer must be configured as a display variable.
To start all totalizers and inventories using the display:
Note
If the PLC is connected and communicating, the start/stop and reset totalizers commands
might be overriding any totalizer commands from the local display or from ProLink III.
1. Scroll until the word TOTAL appears in the lower left corner of the display.
Important
Because all totalizers are started or stopped together, it does not matter which total you
use.
2. Select.
3. Scroll until START appears beneath the current totalizer value.
Micro Motion Model 2700 Transmitters with FOUNDATION Fieldbus