Configuration; Overview; Default Target Mode; Configuration Map - Emerson Micro Motion 2700 Configuration And Use Manual

Chapter 4

Configuration

4.1

Overview

This section describes how to change the operating settings of the transmitter.
Note: All procedures provided in this chapter assume that you have established communication with
the transmitter and that you are complying with all applicable safety requirements. See Appendix C or
the documentation for your PROFIBUS host or configuration tool.
4.2

Default target mode

The default target mode for all blocks is Auto. It is not necessary to set blocks to OOS mode before
changing the parameters described in this chapter.
4.3

Configuration map

Use the map in Table 4-1 to guide you through a complete or partial configuration of the transmitter.
Table 4-1 Configuration map
Topic
Gas standard volume
Measurement units
Petroleum measurement application
Concentration measurement application
Output scale
Process alarms
Alarm severity
Damping
Slug flow
Cutoffs
Measurement mode
Sensor parameters
Display functionality
Configuration and Use Manual
Method
EDD ProLink II Display
✔ ✔
✔ ✔
✔ ✔
✔ ✔
✔
✔
✔ ✔
✔ ✔
✔ ✔
✔ ✔
✔ ✔
✔ ✔
✔ ✔
Section
4.4
✔
4.5
4.6
4.7
4.8
4.9
4.10
4.11
4.12
4.13
4.14
4.15
✔
4.16
47