Emerson Micro Motion 2700 Configuration And Use Manual page 150

Slave Diagnostic Response Bytes
Table E-2 Byte 2
Bit
0
1
2
3
4
5
6
7
Table E-3 Byte 3
Bit
0
1
2
3
4
5
6
7
Table E-4 Byte 4
Bit
0
1
2
3
4
5
6
7
142
Indication
Slave must be parameterized
Static diagnostic: master requesting diagnostics until bit is reset
This bit is always set to 1
Response monitoring/watchdog (1 = ON; 0 = OFF)
Slave is in freeze mode (1 = ON; 0 = OFF)
Slave is in sync mode (1 = ON; 0 = OFF)
Reserved
Slave is deactivated in master parameter set (this is set by the master)
Indication
Reserved (this is always set to 0)
Reserved (this is always set to 0)
Reserved (this is always set to 0)
Reserved (this is always set to 0)
Reserved (this is always set to 0)
Reserved (this is always set to 0)
Reserved (this is always set to 0)
Diagnostic overflow—transmitter has more diagnostic data than it can report
Indication
Master station address
• An address in the range of 0–125 decimal (0x0–0x7D hex) is the address of the
controlling master.
• An address of 255 decimal (0xFF hex) means the slave is not controlled or
parameterized by a master.
Model 2700 Transmitter with PROFIBUS-PA