Emerson Micro Motion 2700 Configuration And Use Manual page 75

Configuration
Table 4-12 Status alarms and severity levels (continued)
Alarm code Index
A103 43
A104 44
A105 45
A107 47
A116 56
A117 57
A120 60
A121 61
A131 71
A132 72
(1) Can be set to either Informational or Ignore, but cannot be set to Fault.
To configure status alarm severity, refer to the flowcharts in Figure 4-11. Some configurable alarms
can be set to either Informational or Ignore, but not to Fault.
Figure 4-11 Configuring status alarm severity
EDD
Configuration and Use Manual
Description
Data loss possible
Calibration in progress
Slug flow
Power reset occurred
API temperature outside standard range
API density out of limits
Concentration measurement: unable to
fit curve data
Concentration measurement: extrapolation alarm
Smart Meter Verification in progress
Simulation mode active
Bus parameters
Select alarm
Set severity
ProLink >
Configuration
Alarm tab
Default
severity
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Block: Transducer Block 1 (Slot 11)
Index 149 (Alarm index)
Block: Transducer Block 1 (Slot 11)
Index 150 (Alarm severity)
ProLink II
Select an alarm from
the Alarm list
Select a severity from
the Severity list
Apply
Configurable
Yes
(1)
Yes
Yes
Yes
Yes
Yes
No
Yes
Yes
(1)
Yes
67