Firmware Update Via Usb Interface; Spare Parts - Roland R1000 Series Manual

B0060191 / Rev. 1.7
10.6

Firmware update via USB interface

The unit is equipped with a separate USB interface (the lower USB slot) for updating the firmware
with help of the supplied RPP7-Software.
According to the operating systems, there are the following software versions:
• RPP7 V1.x
• RPP7 V2.x
• SAM-BA
The instructions of the programs can be accessed via the help function after installation (pdf).
Note the following:
• First, install the software. Then connect the device.
• Your installation directory must have write permissions for later users.
• For connecting use the USB Cable A Plug to A plug (within scope of delivery).
• Connect only one Roland device to a PC.
• The drivers are included on the CD.
• Switch the device to firmware update mode (For details refer to chapter 7.11).
10.7

Spare parts

Roland Electronic recommends to inventory the following spare parts (minimum):
Sensor cables: 1 set of sensor cables, if the cables are exposed to excessive stress (drag chain
Sensors:
Whether a spare control unit should be kept in inventory has to be decided on individual basis.
ROLAND ELECTRONIC GmbH · Otto-Maurer-Str. 17 · DE 75210 Keltern · Phone +49 (0)7236-9392-0 · Fax +49 (0)7236-9392-33
Double Sheet Detector R1000-series I20
with integrated fieldbus interface
for Windows 2000 / XP / Vista / 7
this program is not used for firmware update.
for Windows 7 64 bit (in preparation).
operation a.s.o.).
1 pair of sensors, if the sensors are exposed to excessive stress.
Manual
32 bit
Maintenance
147