Roland R1000 Series Manual page 69

B0060191 / Rev. 1.7
Bytes 21 - 23:
Byte.bit PLC –> R1000 (BIN)
21.0 ---
21.1 ---
21.2 ---
21.3 Material detection with sensor 4
21.4 ---
21.5 ---
21.6 ---
21.7 ---
22.0 ---
22.1 ---
22.2 ---
22.3 ---
22.4 ---
22.5 ---
22.6 ---
22.7 ---
23.0 ---
23.1 ---
23.2 ---
23.3 Teach-In 1-sheet sensor 4
23.4 Teach-In 2-sheet sensor 4
23.5 ---
23.6 ---
23.7 Teach-In Range sensor 4
1)
Ready / ENABLE (via IN/OUT): If 0/0V, then control unit fault. Operator action necessary at the control unit, e.g.
memory fault, voltage missing or too low.
2)
The control unit configuration can be selected 0V active or 24V active for these outputs. This applies also to I/O
outputs.
3)
Sensor selection via process channel or program data.
4)
The measuring value is issued as follows:
High byte (byte 10 resp. 13, 16, 19, 22)
1. Micrometer
2. 1 - 10000 inch
3.
ROLAND ELECTRONIC GmbH · Otto-Maurer-Str. 17 · DE 75210 Keltern · Phone +49 (0)7236-9392-0 · Fax +49 (0)7236-9392-33
Double Sheet Detector R1000-series I20
with integrated fieldbus interface
= 0...16000µm
-5
= 0...6300 x 10
1/10% = 0...9999 1/10%
In the following timing diagrams all outputs and inputs via the bus are
Note
designated as BOUT and BIN, in contrast, the opto coupler interface
uses OUT or IN.
Manual
R1000 -> PLC (BOUT)
Type of material at sensor 4 (1=FE, 0=NF)
Current measuring program S4: Teach-In performed
---
---
2)
Warning
2)
0-sheet sensor 4
2)
1-sheet sensor 4
2)
2-sheet sensor 4
High byte thickness value
Low byte thickness value
Low byte (byte 11 resp. 14, 17, 20, 23)
inch
Communication with the PLC
4)
(sensor 4)
4)
(sensor 4)
69