B0060191 / Rev. 1.7
System parameter 14: Adjusting the measuring mode.
System Parameter: 14
measuring mode
extern continuous
Fig. 107: Adjusting the measuring mode
Possible measurement modes:
• external single:
• demonstration:
• external continuous: The system executes measurements, as long as
external special:
ROLAND ELECTRONIC GmbH · Otto-Maurer-Str. 17 · DE 75210 Keltern · Phone +49 (0)7236-9392-0 · Fax +49 (0)7236-9392-33
Manual
Double Sheet Detector R1000-series I20
with integrated fieldbus interface
The system measures once if the "Measurement start" signal is applied
via the external PLC input. Each measurement must initiated
separately. The notes in chapter 6.3.2 „timing diagram single
measurement" must be observed.
This mode of operation is intended for equipment demonstrations, but
not for normal process operation. The system executes measurements
continuously.
the "Measurement start" signal is applied via the external PLC input.
As for "external continuous", but: The highest value reached during a
measurement cycle is displayed and maintained at the outputs until a
new measurement is started.
This also applies for the outputs 0-1-2-Warning.
Start-up
127