Roland R1000 Series Manual page 111

B0060191 / Rev. 1.7
Program parameter 4: Specifying the material of the sheets to be measured.
Program Parameter: 4
Material
ferrous steel
Fig. 56: Selection of material to be measured
Possible choices:
• Fe (ferrous):
• NF (non-ferrous):
• NF?:
Program parameter 5: Setting the percentage threshold of the lower limit value.
Program Parameter: 5
lower threshold
80%
Fig. 57: Adjusting the upper limit
Value range: between 0% and 99% of the nominal value, with simultaneously displaying the
absolute limit value.
Program parameter 6: Setting the percentage threshold of the upper limit value.
Program Parameter: 6
upper threshold
120%
Fig. 58: Adjusting the lower limit
Value range: between 100% and 180% of the nominal value, with simultaneously displaying the
absolute limit value.
ROLAND ELECTRONIC GmbH · Otto-Maurer-Str. 17 · DE 75210 Keltern · Phone +49 (0)7236-9392-0 · Fax +49 (0)7236-9392-33
Double Sheet Detector R1000-series I20
with integrated fieldbus interface
Magnetic material.
Non magnetic material (e.g. Aluminum, austenitic Stainless Steel)
with known conductivity.
Non magnetic material (e.g. Aluminum, austenitic Stainless Steel)
with unknown conductivity. During Teach-In, the system determines
by itself the conductivity of the material between the sensors.
The user will be asked whether the conductivity is to be determined
now or at a later time.
6.608 mm
12.390 mm
Manual
Start-up
111