Roland R1000 Series Manual page 56

Electrical installation
5.2.3.6 Interbus-S
Input (male connectors) – Pos. C
Male contacts at the control unit (male socket)
2
5
3
View:
plug side
The module supports 500 kbit/s operation. The corresponding cable plugs are part of the standard scope of supply.
5.2.3.7 ProfiNet IO
The ProfiNet connection is implemented as 1-Port.
2
1 3
4
View:
Plug side
5.2.3.8 CC-Link
An M12 plug with A-coding is used for the CC-Link connection. A T-connector is not necessary,
because the control unit is equipped with input and output.
The corresponding cable plugs are part of the standard scope of supply.
M12, 4-pin, A-coded, male connector at control unit
2
3
View:plug side
ROLAND ELECTRONIC GmbH · Otto-Maurer-Str. 17 · DE 75210 Keltern · Phone +49 (0)7236-9392-0 · Fax +49 (0)7236-9392-33
56
Double Sheet Detector R1000-series I20
with integrated fieldbus interface
Allocation of Interbus-S connection
M12, 5-pin, B-coded,
pin 1
pin 2
1
pin 3
pin 4
4
pin 5
Plug enclosure
Allocation of ProfiNet IO connection
Round-shape connector, M12, 4-pin., D-coded, socket contact at control unit (Pos. C)
Pin 1
Pin 2
Pin 3
Pin 4
Plug enclosure
The corresponding cable plugs are part of the standard scope of supply.
If the I20 is the last participant in the bus, then an external
Note
termination resistor should be placed into the open connector. The
resistor is not included in the scope of supply. A resistor between
DA und DB 110 Ohm or 130 Ohm ½ Watt can be used.
Input (Pos. C)
Pin 1
Pin 2
1
Pin 3
4
Pin 4
Pin 5
Suppliers / types / notes: Binder, type 715 (A-coded) and others
Manual
Output (female connectors) – Pos B
Female contacts at the control unit (female socket)
DO
/DO
2
1
5
DI
4 3
/DI
GND
View:
shield
plug side
TD +
RD +
TD –
RD –
Shield
Allocation of CC-Link connection
M12, 5-pin, A-coded, female connector at control unit
B0060191 / Rev. 1.7
M12, 5-pin, B-coded
pin 1
pin 2
pin 3
pin 4
pin 5
Plug enclosure
Output (Pos. B)
SLD
1
DB
DG
4
DA
---
View:plug side
DO
/DO
DI
/DI
GND
shield
2
5
3