Roland R1000 Series Manual page 125

B0060191 / Rev. 1.7
System parameter 8: Deleting all measuring programs.
System Parameter:
clear prog. param.
Fig. 101: Deleting of measuring programs
Possible choices:
• yes
• no
System parameter 9: Switching the password function on / off.
System Parameter:
password active
Fig. 102: Switching the password on / off
Possible choices:
• yes
• no
System parameter 10: Determining a password.
System Parameter: 10
set password I20
0000
Fig. 103: Determining a password
The factory setting of the password is "0000".
ROLAND ELECTRONIC GmbH · Otto-Maurer-Str. 17 · DE 75210 Keltern · Phone +49 (0)7236-9392-0 · Fax +49 (0)7236-9392-33
Double Sheet Detector R1000-series I20
with integrated fieldbus interface
8
no
The deletion cannot be undone.
Attention
9
no
If password protection is not activated, then all parameters can be
Attention
accessed at any time. This is recommended only during starting-up
the system. For daily operation the password function should be
activated.
Manual
Start-up
125