Sflow Commands - D-Link DGS-1210/ME Series Reference Manual

The sFlow commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in
the following table.
Command
enable sflow
disable sflow
show sflow
create sflow
flow_sampler ports
config sflow
flow_sampler ports
delete sflow
flow_sampler ports
show sflow
flow_sampler
create sflow
analyzer_server
config sflow
analyzer_server
delete sflow
analyzer_server
show sflow
analyzer_server
create sflow
counter_poller ports
config sflow
counter_poller ports
delete sflow
counter_poller ports
show sflow
counter_poller
Each command is listed in detail, as follows:
DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide
Parameter
[<portlist> | all] analyzer_server_id <int 1-4> {rate <int 0-65535>} {tx_rate <int 0-
65535>} {maxheadersize <int 18-256>}
[<portlist> | all] [rate <int 0-65535> | tx_rate <int 0-65535> | maxheadersize <int
18-256>]
[<portlist> | all]
<int 1-4> owner <string 16> {timeout [<sec 1-2000000> | infinite] |
collectoraddress [<ipaddr> | <ipv6_addr>] | collectorport <int 1-65535> |
maxdatagramsize <int 300-1400>}
<int 1-4> {timeout [<sec 1-2000000> | infinite] | collectoraddress [<ipaddr> |
<ipv6_addr>] | collectorport <int 1-65535> | maxdatagramsize <int 300-1400>}
<int 1-4>
[<portlist> | all] analyzer_server_id <int 1-4> {interval [disable | <sec 20-120>]}
[<portlist> | all] interval [disable | <sec 20-120>]
[<portlist> | all]

SFLOW COMMANDS

400
52