Error 28-509: Processor Did Not Complete Warm Up - Kodak DryView 6800 Diagnostics Manual
Laser imager
Hide thumbs
Also See for DryView 6800:
- User manual (64 pages) ,
- Quick start manual (1 page) ,
- Specifications (6 pages)
Table of Contents
Advertisement
DIAGNOSTICS
30JUL07
Error 28-509: PROCESSOR Did Not Complete Warm Up
8F2919
Page
224 of 326
Messages
Processor Warm-up Failure
(Alarm sounds)
Description
This error occurs if any PROCESSOR RTD indicates a temperature lower than the setpoint
temperature when the allotted warm up time has elapsed. The allotted time is determined by
the starting PROCESSOR temperature. The error is cleared when power is cycled on the
IMAGER.
Result of Error
The PRINTER cannot print films. The SPOOLER is able to receive and queue jobs but new
films will not be initiated. Films downstream of the subsystem will be completed. All other
films will be reprinted.
User Action
1
Restart the LASER IMAGER from the LOCAL PANEL.
2
If the error occurs again, call Service.
FE Action
Do the actions below in sequence. If an action provides a resolution, do not continue with the
other actions.
1
De-energize then energize the LASER IMAGER.
LOCAL PANEL
LOG
Processor failed to warm up
in the specified time
Status Messages and Error Codes
DICOM
SEVERITY
PROC DOWN
0-Fatal
Advertisement
Table of Contents
