Error 26-325: Jam Entering Exposure Transport - Kodak DryView 6800 Diagnostics Manual

DIAGNOSTICS
30JUL07

Error 26-325: Jam Entering EXPOSURE TRANSPORT

8F2919
Page
174 of 326
Messages
Film Jam in Area 2
(Alarm sounds)
Description
This error occurs if the leading edge is not detected at the EXPOSURE TRANSPORT
ENTRANCE SENSOR (S12) after the film moves from the FILM REGISTRATION area. The
error is cleared when the IMAGER DOORS are opened then closed. Open is indicated by the
I3 INTERLOCK (PROCESSOR and vertical DOOR) open. Close is indicated by the I3
INTERLOCK closed.
Result of Error
The PRINTER cannot print films. The SPOOLER is able to receive and queue jobs but new
films will not be initiated. Films downstream of the subsystem will be completed. All other
films will be reprinted.
User Action
1 Open all DOORS on the IMAGER.
2 Remove any film jams in area 2.
Note
Use the FILM FEED KNOB in area 2 to move the film down to the "bottom" access area.
3 Close all DOORS.
4 If the error occurs again, call Service.
LOCAL PANEL LOG
Film Jam Entering Exposure
Transport: Exposure Entrance
Sensor S12 failed to detect
film leading edge
Status Messages and Error Codes
DICOM SEVERITY
FILM JAM 1-Alert