DIAGNOSTICS
30JUL07
•
Use the FILM FEED KNOB in area 3 to advance the film.
8F2919
Page
•
"Unlatch" and open the PROCESSOR ASSEMBLY
179 of 326
•
Remove any films in area 3.
•
"Relatch" and close the PROCESSOR ASSEMBLY.
4
Close all DOORS.
5
If the error occurs again, call Service.
FE Action
Do the actions below in sequence. If an action provides a resolution, do not continue with the
other actions.
1
De-energize then energize the LASER IMAGER.
2
Do the following:
For film jam in areas 3 and 4
FILM CARTRIDGE
BELTS
DENSITOMETER FILM
DETECT SENSOR - use the
SERVICE TOOL
3
Install a new TURNAROUND AY. See the ADJUSTMENTS AND REPLACEMENTS,
TURNAROUND AY - IMAGER with
Check:
Remove films.
Install a new FILM CARTRIDGE.
Install new BELTS.
Install a new TURNAROUND AY. See the
ADJUSTMENTS AND REPLACEMENTS,
TURNAROUND AY - IMAGER with
If an existing problem:
SORTER.
Status Messages and Error Codes
SORTER.