Error 21-118, 22-118, Or 23-118: Pickup Did Not Go Home - Kodak DryView 6800 Diagnostics Manual

DIAGNOSTICS
30JUL07

Error 21-118, 22-118, or 23-118: PICKUP Did Not Go Home

8F2919
Page
127 of 326
Messages
xxxxx Supply: Internal
Hardware Failure
(Alarm sounds)
Description
Note
UPPER DRAWER (U) = 21. MIDDLE DRAWER (M) = 22. LOWER DRAWER (L) = 23.
This error occurs if the PICKUP ASSEMBLY does not leave the Home position at the
beginning of a pickup cycle or does not reach Home position at the end of the pickup cycle,
as indicated by the PICKUP HOME SENSOR (S1x). The error is cleared when the IMAGER
power is cycled.
Result of Error
The system cannot make a print from the SUPPLY DRAWER. The SPOOLER is able to
receive and queue jobs, and print from any other available SUPPLY DRAWER.
User Action
1 Restart the LASER IMAGER from the LOCAL PANEL.
2 If the error occurs again, call Service.
FE Action
Do the actions below in sequence. If an action provides a resolution, do not continue with the
other actions.
1 De-energize then energize the LASER IMAGER.
LOCAL PANEL LOG
xxxxx Supply: Pickup Home
Sensor (S1) failed to sense
pickup assembly.
Status Messages and Error Codes
DICOM SEVERITY
FILM TRANS 1-Alert
ERR