Siemens SINAMICS PERFECT HARMONY GH180 Function Manual page 331

Stop mode
Stop mode is used to shut down the drive in a controlled manner, regardless of its current
state.
Submenus
A submenu is one of four components found in the menu system. Submenus are nested menus
(i.e., menus within other menus). Submenus are used to logically group menu items based on
similar functionality or use.
Synchronous speed
Synchronous speed refers to the speed of an AC induction motor's rotating magnetic field. It
is determined by the frequency applied to the stator and the number of magnetic poles present
in each phase of the stator windings. Synchronous Speed equals 120 times the applied
Frequency (in Hz) divided by the number of poles per phase.
System Operating Program
The functions of the programmable inputs and outputs are determined by the default system
program. These functions can be changed by modifying the appropriate setup menus from the
front keypad and display. I/O assignments can also be changed by editing the system program
(an ASCII text file with the extension .SOP), compiling it using the compiler program, and then
downloading it to the controller through its serial port, all by utilizing the SOP Utility Program
with the Siemens ToolSuite.
Tool Suite
Is the suite of programs developed by Siemens that allows easier access to the drive for
programming and monitoring. It is comprised of the following components:
● Tool Suite Launcher - also referred to as Tool Suite; used for coordinating other tools.
● SOP Utilities - used to launch an editor that compiles or reverse compiles a System
Program. It also allows for serial connection to the drive for uploading and downloading
System Programs.
● Configuration Update - allows for backing-up, updating, and cloning drives via direct access
to the Flash Disk.
● Host Simulator - used for monitoring, programming, and controlling a drive remotely from
a PC over the built-in ethernet port of the drive. Parameter changes, status display, and
graphing of internal variables are its main functions.
● Debug Tool - this tool is used to display the diagnostic screens of the drive for diagnosing
drive problems or improving performance via the built-in ethernet port of the drive.
Tool Suite Launcher
see Tool Suite definition.
NXGpro Communication
Function Manual, AB, A5E33486415A
Glossary
331