Available Id Function Commands - Siemens SINAMICS PERFECT HARMONY GH180 Function Manual

PTD Register Register Function
PTD3 Write Value
PTD4 Write Value
The following table lists the available ID Function commands for use when PTD1 is set to a
"Function command" (value 41).
The table also lists the PTD and PFD usage for each parameter function.
Table E-3

Available ID Function Commands

Parameter ID Function
1260 Autotune Stage1
1270 Autotune Stage2
2640 Reset Bypassed Cells
3510 Start Control Loop Test
3520 Stop Control Loop Test
5045 Set Current As Default
5050 Reset to Defaults
6200 Clear Event Log
6240 Alarm/Fault Log Clear
8030 Preset Hour Meter
8040 Reset Hour Meter
8060 Alarm/Fault Log Clear
8070 Reset Output KWH Meter
8074 Preset Input KWH Meter
8076 Reset Input KWH Meter
NXGpro Communication
Function Manual, AB, A5E33486415A
Value Description
N/a Value to be used for write parameter value command for Least
Significant 16-Bits
N/a Value to be used for write parameter value command for Most
Significant 16-Bits
PTD Use
Not used
Not used
Not used
Not used
Not used
Not used
Not used
Not used
Not used
● PTD3 = Value
● PTD4 = Exponent
Not used
● PTD3 = Value
● PTD4 = Exponent
Not used
● PTD3 = Value
● PTD4 = Exponent
Not used
Parameter Read/Write
E.3 Defining the PTD Registers
PFD Use
Not used
Not used
Not used
Not used
Not used
● PFD3: 1 = Error
● PFD4: Not used
Not used
Not used
● PFD3: 1 = Error
● PFD4: Not used
Not used
Not used
Not used
Not used
Not used
Not used
307